TotalPhase Settings

CAN Settings is used to set up your CAN interface.

Add a new CAN interface by clicking the UnAssigned device in the left-side window, then selecting your CAN interface from the Hardware drop-down box.

Configurable Settings

Software CAN Channels

You may add up to 9 software channels and assign a CAN interface to them. Channels are used to manage multiple interfaces.

Channel Active

Un-checking Channel Active disables the channel, in case you do not want this CAN interface to participate in the bus communication, but want to preserve the settings for future use.

Silent Mode

Configure the CAN interface to work in silent mode (won't transmit anything, won't set the ACK bit of the received messages) if the CAN interface supports silent mode.

Bitrate

Select the baudrate of the CAN interface. The supported baudrates for TotalPhase CAN interfaces are:

---

Classical CAN Configuration

Supported Baudrate
1 Mbit/s
500 kbit/s
250 kbit/s
125 kbit/s
100 kbit/s
83,3 kbit/s
50 kbit/s
20 kbit/s

Sampling point

Due to hardware limitations of TotalPhase devices, the sampling point cannot be adjusted.